Tips for The Average Joe

Simple Steps in Garage Door Cable Replacement

The average garage door is composed of various parts that work together to make the door work. Cables are a crucial component of any garage door. Garage door cables are also known as torsion springs. A lot of people still get confused about these terms because they often hear experts say a cable or a spring to mean the same thing. It is important to note, though, that these garage door cables only become springs when you wound them around a shaft. Without doing any winding, then you only refer to this part as a cable. In short, the terms cable and spring are applicable to this part of your garage door.

As much as possible, you should only use quality garage door cables as a homeowner. You know you have reliable cables when they are made of steel wire that is sturdy. No matter how you take care of your garage door, these cables can break as time goes by. The average lifespan of garage door cables is between three and seven years. How many times you close or open these doors will have an effect on the lifespan of your cables. This is one of the reasons why homeowners only close or open then when necessary.

If one garage door cable breaks, the other one also breaks in just a short span of time. This is why buying these cables must come in pairs. You should also replace these two cables at once. The task of either installing or replacing garage door cables is going to be risky and requires a lot of work.

This task is dangerous because you will be dealing with high-tension springs. At this point, if you don’t know what tools you require and how to use them, then you are better off seeking the help of a professional. The springs are dangerous, especially when they break. It’s a good thing that this often happens during the closing process than the opening process. If someone is inside the garage, a loose piece of cable might endanger them. To avoid this scenario, many manufacturers place safety mechanisms.

This site will give you more information for more about replacing garage door cables yourself. The first step to replacing your cables is to measure your existing cables. The typical cable length is around 7 to 8 feet. Most of the time, measuring a broken cable is difficult so you may inquire from the manufacturer about the length or simply go online.

You have to remove existing springs if you want to install a new garage door cable. There are tools you can use to cut or unwind this spring. After removing the old spring from the shaft, you can proceed to wind your new garage door cables.

What Has Changed Recently With ?

The Beginners Guide To (From Step 1)